top of page

Hot tub and swim spa electrical requirements

Most hot tubs we sell need their own 240-volt circuit, put in by a licensed electrician before delivery day. Here is what to plan for, what it usually costs, and what to hand your electrician.

 

What most hot tubs need

A dedicated 240-volt circuit, typically 50 amps, run from your main panel. A GFCI-protected disconnect, mounted within sight of the tub and at least 5 feet from the water. A licensed electrician and, where your city or county requires one, a permit and inspection.

A few small spas run on a standard 120-volt plug, and some models call for a different circuit size. Every listing on our site shows that model’s electrical requirement under Specs.

 

Swim spas

Swim spas need a dedicated circuit too, sized by model. A dual-temperature swim spa has two heaters, so its circuit is sized for both. As an example, the Endless Pools X2000 available runs on 230 volts with a 30-amp circuit (60 amps optional).

 

What it costs

Commonly several hundred dollars to a couple of thousand, depending on how much spare capacity your panel has and how far the tub sits from it. A panel upgrade, if your panel is full, is extra. We include the electrical in your delivered-total quote when you want us to coordinate it.

 

How we handle it

We give your electrician the spec sheet for the exact model before delivery, and we can put you in touch with electricians we work with. Schedule the electrical alongside the pad, so the tub can be filled and heated the day it arrives.

 

Before you call an electrician

Pick the spot for the tub and note how far it is from your panel. Take a photo of the panel with the door open. Send us the listing for the model you are buying, and we will send the spec sheet.

 

Electrical codes vary by city and county. Your electrician and local inspector have the final word on what your installation needs.

bottom of page