top of page

What the Code on Your Hot Tub Panel Means

Writer: Chip & Mandy Stewart
Chip & Mandy Stewart
Nov 8
2 min read

A code on the panel isn't always bad news. Some are reminders. Some are the spa protecting itself. A few mean it needs a service call. Here's how to tell which is which.

One warning first. Each control system maker uses its own codes, and the same letters can mean different things on different spas. On many Balboa systems HL means low flow through the heater, while on some Gecko systems it means the water in the heater got very hot. Your owner's manual has the exact list for your spa and is the final word.

Flow codes: FLO, FL, LF, HFL

The spa isn't moving enough water through the heater, so it stops heating to protect itself. You can safely check:

  • The water level. Too low and the pumps pull air.

  • The filter. A dirty filter is the most common cause. Turn the spa off, then rinse or swap it.

  • Any valves or diverters that are closed.

  • An air lock, especially right after a refill. Run each pump on high to push the air out.

If the code keeps coming back after those checks, call us.

Overheat codes: OH, OHS, OHH, HH, HOT

Stay out of the spa until it's sorted out. Take the cover off, check the water with a thermometer and let it cool. In a Texas summer, hot afternoons plus long filter cycles can push the water past the set point, so shortening the filter cycles can help.

If the code points to the heater itself, such as OHH or HH, or it comes back, call us. That one needs a technician.

Sensor codes: SnA, Snb, Sns, Sn, Prr

A temperature sensor isn't reading correctly. Turn the spa off at the breaker for a minute and back on once. If the code returns, the sensor or a connection needs service, so call us.

Freeze codes: ICE, IC

The spa sensed near-freezing temperatures and is running its pumps to protect the plumbing. That's the spa doing its job. Leave it powered on with the cover closed. Our hard freeze guide covers what to do in a cold snap.

Dashes instead of a temperature

Some panels show dashes when the spa hasn't run a pump recently and doesn't have a fresh reading, for example in economy or sleep mode. Run a pump for a minute and the temperature usually comes back.

Reminder messages

Messages like CHNG WATR, CLN FLTR or CHEK PH are timers, not faults. Do the task, then clear the reminder the way your manual shows.

No power or a tripped GFCI

If the panel is dark, check the GFCI breaker. If it trips again after you reset it, stop resetting it and call us. Repeated trips mean something needs to be looked at.

Before you call

Write down the exact code, what the spa was doing when it appeared, and your model. Never open the equipment bay with the power on. Call 936.333.0770 or email sales@txspaguy.com and we'll tell you whether it's something you can fix or a service visit.

bottom of page