First Fill and Start-Up: Getting a Hot Tub Running the Right Way

Whether your spa is brand new or you just drained it, a start-up goes in the same order every time. Most problems people call us about in the first week come from doing these steps out of order, so here they are in order.
Before any water goes in
Turn the spa off at the breaker, not just at the panel.
Make sure the drain valve is closed and its cap is on.
Open the equipment door and check that the pump and heater unions are hand tight. Fittings can work loose in transport.
Wipe out any dust or leaves sitting in the shell and the filter well.
Fill it through the filter well
Put the hose into the filter well, not into the footwell. Filling through the filter housing pushes water through the plumbing from the right direction and cuts down on air trapped in the lines.
North Texas tap water is hard. A pre filter that screws onto the end of the hose is cheap and takes a lot of calcium out before it ever reaches your heater.
Fill to the level your owner's manual shows, usually about halfway up the skimmer opening. Too low and the pumps pull air. Too high and the skimmer stops working.
Power on and purge the air
Turn the breaker back on. Many control systems run a priming mode for a few minutes after power up. Use that time to run each pump on low and then high, one at a time, so trapped air works its way out.
If a pump hums but water doesn't move, that's an air lock. Turn the spa off at the breaker, loosen the union on top of that pump just until water dribbles out, tighten it back up, and power on again. If you're not comfortable doing that, call us and we'll talk you through it.
Balance the water, in order
Alkalinity first, then pH, then sanitizer, then calcium. Chasing pH while alkalinity is off is the most common reason new owners feel like they're fighting their water.
Total alkalinity: 80 to 120 ppm
pH: 7.2 to 7.8
Chlorine: 1 to 3 ppm, or bromine: 3 to 5 ppm
Calcium hardness: 150 to 250 ppm
Follow the label on each product for the amount, and let the pumps run between additions.
Let it heat with the cover on
Heating a full spa from tap temperature takes a while. A 240-volt hot tub climbs a few degrees an hour, so plan on most of a day. A swim spa holds several times the water and takes longer. Keep the cover on and locked the whole time; it makes a big difference.
Before your first soak
Make sure the water is at temperature and the sanitizer and pH are in range. Then set your filter cycles from the manual.
For the first week, test every day. New water moves around while it settles. After that, twice a week is plenty.
When to call us
Call if the GFCI breaker trips, if a code on the panel won't clear, if you see water in the equipment bay, or if the spa hasn't gained any heat after a full day. Call 936.333.0770 or email sales@txspaguy.com and tell us what you're seeing.



